Polyester staple fiber is produced by feeding polyester (PET) melt into the spinning machine; or using polyester chips as raw materials, drying, melting and feeding into the spinning machine, then bundling, stretching, shaping, Curl, cut, pack, and obtain polyester staple fiber.

Safety points for producing polyester staple fiber

1. Control the operation of slice drying and melt spinning to promote smooth operation.

2. Screw extrusion melt spinning is heated with a biphenyl heat carrier. When biphenyl is heated, exhaust gas is required, and the exhaust gas should be slow to avoid taking out the biphenyl. When the exhaust is exhausted, the open flame is strictly prohibited and should not be discharged into the room to avoid fire and poisoning.

The temperature of this post is high, and it is necessary to do a good job of cooling down the DF.

3. The winding speed of the winder is very high. It is easy to bring the hook into the handle during the operation, causing the flying hook to hurt people. Therefore, educate the manipulators to concentrate on maneuvering and stand in a favorable and safe position to avoid flying hook damage.

When winding the wire onto the waste wire roll, if a few bundles of wire have been wound on the roll, and then use one hand to hold the original tow when winding the wire, so as to prevent the tow from rolling the hook and causing the flying hook.

When cutting the waste wire on the waste wire roller, be sure to use the foot to step on the brake device. After stopping, use a knotting knife to cut the waste wire.

4. When raising and lowering the buncher, it is strictly forbidden to stand.

5. When handling the drafting and wrapping rolls, be sure to slow down or stop the treatment. When hooking the wire, concentrate on hooking the wire at the exit to prevent hooking.

6, pay attention to the oil can not overflow, once splashed on the ground should be washed in time to prevent walking slip.

7. When the cutting machine is turned on, the hand holding the wire head is sent to the cutting hook wheel. If the matching is improper, it is easy to cause the hand has not left, the console has been turned on, and the Hand is brought in, causing a hand cutting accident., the operation of the cutting machine must be closely coordinated, and must be turned on after the hand leaves.

8. In the packaging process, the main gland should be wrapped in the cloth when the machine is stopped, and then the main gland should be raised. Never put the main cover on the top cover to prevent the hand from being squeezed.

9, to do a good job in the fire prevention of fiber warehouses.

10, not allowed to "shawl hair" to work. The lesbians want to cover their hair in the work cap, and they are not allowed to wear high heels and wear jewelry.

11, the plant noise is large, pay attention to personal protection.

12, maintenance workers to the high temperature post for inspection, to wear protective equipment to prevent burns.